RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Table 15-32 IP Network Service - IP Parameters
Field Description
Chapter 15-Network Services
IP Network Type Select the IP Network environment. You can select:
• H.323: For an H.323-only Network Service.
• SIP: For a SIP-only Network Service.
• H.323 & SIP: For an integrated IP Service. Both H.323 and SIP
participants can connect to the MCU using this service.
Note: This field is displayed in all Default IP Service tabs.
Signaling Host IP
Address
Media Card 1 Port 1
IP Address
Media Card 1Port 2
IP Address 2
Media Card 2 Port 1
IP Address
(RMX 2000/4000)
Media Card 2 Port 2
IP Address
(RMX 2000/4000)
Media Card 3 Port 1
IP Address
(RMX 4000)
Media Card 3 Port 2
IP Address
(RMX 4000)
Media Card 4 Port 1
IP Address
(RMX 4000)
Media Card 4 Port 2
IP Address
(RMX 4000)
Enter the address to be used by IP endpoints when dialing into the
MCU using this Network Service.
Dial out calls of participants to whom this network service will be
assigned are initiated from this address.
This address is used to register the RMX with a Gatekeeper or a SIP
Proxy server residing on this network.
If only one network is connected to this media card, it is enough to
assign one media card to this Network Service. In such a case, enter
one IP address for the media card according to the LAN Port used for
the connection.
If each of the LAN ports on one media card is used with two different
networks, each port is assigned to its own Network Service. In such a
case, enter the IP address of the port to be assigned to this Network
Service.
A LAN port that is already assigned to a different Network Service,
displays the IP Address of the assigned port and it cannot be
assigned to this Network Service (it is disabled).
If only one network is connected to this media card, it is enough to
assign one media card to this Network Service. In such a case, enter
one IP address for the media card according to the LAN Port used for
the connection, as provided by the network administrator.
If each of the LAN ports on one media card is used with two different
networks, each port is assigned to its own Network Service. In such a
case, enter the IP address of the port to be assigned to this Network
Service.
Notes:
• LAN Ports/Media cards that are already associated with another
Network Service cannot be associated with this Network Service.
• You can define a Network Service without assigning media cards
to it.
• To change the assignment of a card from one service to another,
the card must first be removed from the service to which it is
assigned prior to its assignment to another service.
RMX 2000: If one card was already assigned to another service, only
one additional card can be assigned to this service.
RMX 4000: Depending on the number of media cards installed in the
system, you can assign up to 4 media cards to this network service
provided that they are not assigned to any other Network Service.
Subnet Mask Enter the subnet mask of the MCU in that network service.
Default value: 255.255.255.0.
Polycom, Inc. 15-55