RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Table B-1 Alarms (Continued)
Alarm Code Alarm Description
DEBUG mode enabled Possible explanations:
• System is running in DEBUG mode.
• System DEBUG mode initiated.
DEBUG mode flags in use System is using DEBUG CFG flags.
Appendix B-Alarms and Faults
DMA not supported by IDE device Possible explanations:
• DMA (direct memory access) not supported by IDE device: Incompatible
flash card / hard disk being used.
• Flash card / hard drive are not properly connected to the board / one of the
IDE channels is disconnected.
• DMA was manually disabled for testing.
DNS configuration error
DNS not configured in IP Network Service
Encryption Server Error. Failed to
generate the encryption key
Error in external database certificate
FIPS 140 test failed while generating the new encryption key.
Error reading MCU time Failed to read MCU time configuration file ([status]).
External NTP servers failure
Failed to access DNS server Failed to access DNS server.
Failed to configure the Media card IP
address
Possible reasons for the failure:
• Failure type: [OK Or Not supported.
• Does not exist Or IP failure.
• Duplicate IP Or DHCP failure.
• VLAN failure Or Invalid: [status_Number].
Failed to configure the Users list in Linux External NTP server failure:
NTP server failure: [server0_ip], [server1_ip], [server2_ipStr].
Failed to connect to application server Possible reasons for the failure:
• Failed to connect to application server:
• Failed to establish connection to server, url = [url].
Failed to connect to recording device The MCU could not connect to any of the defined NTP server for
synchronization due to the remote server error.
Failed to connect to SIP registrar Cannot establish connection with SIP registrar.
Failed to create Default Profile Possible reasons for the failure:
• Failed to validate the Default Profile.
• Failed to add the Default Profile.
Failed to initialize the file system Possible reasons for the failure:
• Failed to initialize the file system.
• Failed to initialize the file system and create the CDR index.
Polycom, Inc. B-3