MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN P7600
Name Interceptor, Solids, Large Capacity, Floor Type
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 4510
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 0
Utility2: Electrical . |
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 0
Phase2 0
Amps1 0
Amps2 0
Weight (lbs) 140 Weight (kgs) 64
Height (in) 17 Height (cen) 43
Width (in) 18 Width (cen) 46
Depth (in) 18 Depth (cen) 46
Volts2 0
Hertz 0
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 0
Watts2 0
Description
Unit of Issue EA
Group Plumbing Fixtures
A solid/sediment interceptor that is flush with or on the floor, large capacity, with a coated steel or coated cast iron body. Furnished with
2 inch low inlet and high inlet. Unit provides a means of collecting solids such as metal chips and plaster before entering the drain line. It
is cleaned by removing cover and lifting strainer and screen assembly vertically out of the body. For general purpose use in areas where it
is necessary to preclude solids from entering the drain lines. Note: This unit is not for installation in an undercounter or base sink cabinet.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 1164 of 1462