MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN T0285
Name Drill Press, Floor Mounted, Tilt Table
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 3413
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical D | 120 and 208/220 volt
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 16
Amps2 0
Weight (lbs) 256 Weight (kgs) 117
Height (in) 70 Height (cen) 178
Width (in) 18 Width (cen) 46
Depth (in) 28 Depth (cen) 71
Volts2 0
Hertz 60
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 1920
Watts2 0
Description
Unit of Issue EA
Group Shop Equipment/Tools
Floor mounted drill press. Characteristics/components include 1/2 inch drill capacity; tilt table that tilts 45 degrees; 3/4 HP motor; threespoke
pilot wheel; depth stop and gauge. The unit is used for general purposes in occupational therapy.
JSN T0400
Name Grinder, Floor Mounted, Pedestal
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 3413
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 13
Amps2 0
Weight (lbs) 180 Weight (kgs) 82
Height (in) 58 Height (cen) 147
Width (in) 24 Width (cen) 61
Depth (in) 15 Depth (cen) 38
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1560
Watts2 0
Description
Unit of Issue EA
Group Shop Equipment/Tools
Floor mounted grinder. Characteristics/components include pedestal type with a 1 HP motor; cast iron wheel guard and dust vents; large
eye shields with quick adjustment levels; pre-lubricated with enclosed ball bearings; and two grinding wheels. This unit is used for general
purposes in maintenance shops. Models are also available in 230 VAC, 3 phase.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 1269 of 1462