MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN D3550
Name Evacuation System, Laboratory, Dental
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 230
Utility2: Electrical G | 208/220 volt, 3 phase
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 3
Phase2 0
Amps1 30
Amps2 0
Weight (lbs) 630 Weight (kgs) 286
Height (in) 112 Height (cen) 284
Width (in) 50 Width (cen) 127
Depth (in) 36 Depth (cen) 91
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 11951
Watts2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
High vacuum laboratory evacuation station. The system is used in dental laboratories to provide a vacuum for up to twelve 3 inch suction
inlets throughout the laboratory. The unit has a suction capacity of 1800 cubic feet per minute.
JSN D3560
Name Curing Unit, Denture, 2 Stage
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 6520005977749
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 220
Utility2: Electrical C | 208/220 volt
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 1
Amps1 12
Amps2 10
Weight (lbs) 46 Weight (kgs) 21
Height (in) 19 Height (cen) 48
Width (in) 15 Width (cen) 38
Depth (in) 20 Depth (cen) 51
Volts2 115
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 2640
Watts2 1150
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Two stage denture curing unit. The unit is used in dental laboratories to polymerize heat cured denture resins. The unit is a two stage,
two flask minimum capacity unit with a temperature range of 90 to 212 degrees Fahrenheit. The unit timer ranges from 15 minutes to 23
hours and automatically shuts the unit off at the completion of its cycle. The oven has a safety thermostat to preclude hazardous
temperature levels. The unit also has removable covers and tanks.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 200 of 1462