MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN L2255
Name Canopy, Hood, Exhaust Stack, Individual
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6640
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 0
Utility2: Electrical . |
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc E | Vent to atmosphere
Phase1 0
Phase2 0
Amps1 0
Amps2 0
Weight (lbs) 0 Weight (kgs) 0
Height (in) 0 Height (cen) 0
Width (in) 0 Width (cen) 0
Depth (in) 0 Depth (cen) 0
Volts2 0
Description
Unit of Issue EA
Group Laboratory Equipment
Canopy fumehood. The unit is fabricated from corrosion resistant steel or aluminum, dimensions as indicated on design drawings, fire
suppression systems and any other special requirements to be defined during the facility design. This approximate 9 inch by 9 inch
canopy hood provides for removal of the exhaust from the exhaust stack of an atomic absorption spectrophotometer or flame
photometer used in clinical or research laboratory settings. Canopy attaches to a dedicated exhaust stack which is part of the building
HVAC system. Device does not have any local motor/blower and flow rate is to be determined by the A&E's mechanical engineers.
Hertz
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 0
Watts2 0
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 759 of 1462