MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN L9711
Name Table, Autopsy, Stationary-Fixed-Height
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6530
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing D | Cold and hot water and drain
Volts1 115
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 15
Amps2 0
Weight (lbs) 650 Weight (kgs) 296
Height (in) 37 Height (cen) 94
Width (in) 32 Width (cen) 81
Depth (in) 104 Depth (cen) 264
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1725
Watts2
Description
Unit of Issue EA
Group Laboratory Equipment
Autopsy table shall be constructed of stainless steel. It shall be polished to a smooth finish without crevices, lapped edges, rivets, or
bolts. Table comes with integrated sink, waste disposer, grid plates for flat work area and perimeter downdraft.
JSN L9712
Name Table, Autopsy, Stationary-Elevating
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6530
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing D | Cold and hot water and drain
Volts1 115
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 15
Amps2 0
Weight (lbs) 750 Weight (kgs) 341
Height (in) 39 Height (cen) 99
Width (in) 32 Width (cen) 81
Depth (in) 104 Depth (cen) 264
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1725
Watts2
Description
Unit of Issue EA
Group Laboratory Equipment
Autopsy table shall be constructed of stainless steel and adjust in height by means of electro-hydraulics. The table shall be polished to a
smooth finish without crevices, lapped edges, rivets or bolts. Table comes with integrated sink, waste disposer, grid plates for a flat work
area and perimeter downdraft .
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 819 of 1462