MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN V0060
Name Washer/Sanitizer, Cage, Large
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6640
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing D | Cold and hot water and drain
Volts1 230
Utility2: Electrical F | Special electrical requirements
Utility3: Med Gas D | Air, high pressure (85 PSIG) max
Utility4: Misc Gas A | Steam
Utility5: Non-Med Gas . |
Utility6: Misc E | Vent to atmosphere
Phase1 3
Phase2 3
Amps1 70
Amps2 60
Weight (lbs) 12000 Weight (kgs) 5448
Height (in) 96 Height (cen) 244
Width (in) 54 Width (cen) 137
Depth (in) 336 Depth (cen) 853
Volts2 208
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 24000
Watts1 27886
Watts2 21616
Description
Unit of Issue EA
Group Veterinary
Large cage washer/sanitizer. Characteristics/components include enclosed steam cabinet; type 304 CRS; large capacity water tank; 36 inch
wide CRS conveyor belt with speed controller; 7 HP pre-wash pump motor; 7 HP pump motor for wash and rinse section; automatic
controls in NEMA-12 housing; start-stop buttons in oil-tight switch boxes at each end; thermostatically controlled heaters to provide 110-
120 degree F. pre-wash water, 160-170 degree F. wash water and 170-180 degree F. rinsing-sanitizing water; vent stacks with automatic
dampers; marine light in tunnel; 1/2 inch NPT cold water (20-50 PSIG), 1-1/4 inch NPT hot water (20-60 PSIG), 1-1/4 inch steam (10-60
PSIG), 3/4 in NPT return, 3 inch NPT drain and 8 inch diameter vent; and capacity of 3,000 cages in 6 hours. Unit is used for processing
cages and accessories.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 1310 of 1462