MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN K3600
Name Steamer, Stack, 2 Compartments, Gas Boiler
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 7310
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing B | Cold water and drain
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas A | Natural gas
Utility6: Misc E | Vent to atmosphere
Phase1 1
Phase2 0
Amps1 7
Amps2 0
Weight (lbs) 750 Weight (kgs) 341
Height (in) 72 Height (cen) 183
Width (in) 25 Width (cen) 64
Depth (in) 36 Depth (cen) 91
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 200000
Watts1 840
Watts2 0
Description
Unit of Issue EA
Group Food Service Equipment
Stack steamer. The unit is made of stainless steel and features two pressureless steamer compartments above a gas fired boiler (electric
boilers are available). Each compartment has its own sealed door and a switch which turns off the blower and steam supply to that
compartment when the door is opened. A further safety shuts the unit off if the water level in the boiler gets too low or the steam
pressure gets too high. A drip sink for catching condensation is positioned under the compartments. A side access door allows
maintenance and repair of piping and other utilities. See manufacturers' installation notes for locating the drain for this unit and the
required minimum clearances from combustible materials.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 646 of 1462