MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN D0750
Name Tank Assembly, Boilout
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing D | Cold and hot water and drain
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas A | Natural gas
Utility6: Misc E | Vent to atmosphere
Phase1 1
Phase2 0
Amps1 5
Amps2 0
Weight (lbs) 175 Weight (kgs) 80
Height (in) 24 Height (cen) 61
Width (in) 14 Width (cen) 36
Depth (in) 18 Depth (cen) 46
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 600
Watts2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Drop-in boil-out tank assembly. The unit consists of a stainless steel tank with cover, heat rectifier assembly, gas burner and adjustable
thermostat and is used in dental laboratories. The bench top cut out size is approximately 10-7/8" wide x 16-7/8" deep. This unit requires
a cabinet for mounting.
JSN D0753
Name Tank Assembly, Curing
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing D | Cold and hot water and drain
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas A | Natural gas
Utility6: Misc E | Vent to atmosphere
Phase1 1
Phase2 0
Amps1 5
Amps2 0
Weight (lbs) 175 Weight (kgs) 80
Height (in) 24 Height (cen) 61
Width (in) 14 Width (cen) 36
Depth (in) 18 Depth (cen) 46
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour
Watts1 600
Watts2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Stainless steel sink unit for curing denture material. The sink is approximately 10" wide x 14" deep x 12" deep and uses gas heating
elements. The unit requires an appropriate cabinet for mounting.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 171 of 1462