MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN D4361
Name Heater, Duplicating Colloid
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 8
Amps2 0
Weight (lbs) 50 Weight (kgs) 23
Height (in) 27 Height (cen) 69
Width (in) 14 Width (cen) 36
Depth (in) 14 Depth (cen) 36
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch -1
BTU / Hour 0
Watts1 960
Watts2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Heater for the duplicating colloid used in dental laboratories. The unit heats duplicating colloid to the correct temperature for use and
maintains that temperature until the technician dispenses the colloid into a prosthetic mold or other dental model. The unit has
approximately a 2 gallon capacity and the temperature control keeps the colloid within 5 degrees (above or below) of the temperature set
by the technician.
JSN D4370
Name Heater, Duplicating Colloid, Automatic
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 15
Amps2 0
Weight (lbs) 76 Weight (kgs) 35
Height (in) 27 Height (cen) 69
Width (in) 18 Width (cen) 46
Depth (in) 19 Depth (cen) 49
Volts2 0
Hertz 50/60
Hertz Dep 0
Hertz Switch -1
BTU / Hour 0
Watts1 1800
Watts2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Automatic dental colloid heater and holding tank. The unit is used in dental laboratories to process, hold and dispense hydrocolloid for
dental model duplicating work. The heater has adjustable temperature controls, automatic timing controls and a three gallon capacity.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 209 of 1462