MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN A6160
Name Bumper, Dock
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 5680
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 0
Utility2: Electrical . |
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 0
Phase2 0
Amps1 0
Amps2 0
Weight (lbs) 81 Weight (kgs) 37
Height (in) 12 Height (cen) 30
Width (in) 36 Width (cen) 91
Depth (in) 6 Depth (cen) 15
Volts2 0
Hertz 0
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 0
Watts2 0
Description
Unit of Issue EA
Group Architectural
Unit attaches to the face of the dock for easy installation by bolting or welding. The bumper block is constructed from the same material
used in the manufacture of heavy tire cord. Used to protect vehicles and docks against impacts when positioning the vehicles to the dock
for loading and unloading of merchandise. Size and shape of the bumper block will vary depending on the application.
JSN A6165
Name Station, Pneumatic Tube System
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 5680
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 0
Utility2: Electrical . |
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 0
Phase2 0
Description
Unit of Issue EA
Group Architectural
The basic pneumatic tube system consists of a tube linking two or more different locations, a carrier to carry the payload and a power
source to move the carrier from one location to another. The systems becomes more complex when the system is expanded to a network
containing hundreds of locations and dozens of zones that need to transport the payload simultaneously.
C
Amps1 0
Amps2 0
Weight (lbs) 0 Weight (kgs) 0
Height (in) 0 Height (cen) 0
Width (in) 0 Width (cen) 0
Depth (in) 0 Depth (cen) 0
Volts2 0
Hertz 0
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 0
Watts2 0
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 90 of 1462