MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN M4865
Name Reprocessor, Renal Dialyzer Cartridge
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 4100
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing E | Treated water and drain
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc E | Vent to atmosphere
Phase1 1
Phase2 0
Amps1 15
Amps2 0
Weight (lbs) 127 Weight (kgs) 58
Height (in) 16 Height (cen) 41
Width (in) 15 Width (cen) 38
Depth (in) 13 Depth (cen) 33
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1800
Watts2 0
Description
Unit of Issue EA
Group Miscellaneous
Renal dialyzer disinfection system. Unit is used to flush and disinfect dialyzer cartridges after a hemodialysis session. The unit then refills
the cartridge with preservative for storage until reuse by the same patient during a later session. The manufacturer recommends a
dedicated 20 amp ground fault interrupt protected power circuit for this equipment. See manufacturer's pre-installation checklist for
ventilation requirements. Use JSN M4850 to remove disinfectant from dialyzer cartridge prior to use.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 949 of 1462