MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN L2280
Name Hood, Laminar Flow, Horizontal, Free Standing, 6ft
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 6640
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical B | 120 volt, special outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 19
Amps2 0
Weight (lbs) 680 Weight (kgs) 309
Height (in) 84 Height (cen) 213
Width (in) 74 Width (cen) 188
Depth (in) 34 Depth (cen) 86
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 2280
Watts2 0
Description
Unit of Issue EA
Group Laboratory Equipment
Horizontal laminar flow hood. This is a freestanding unit that meets or exceeds Class 100 requirements set for Federal Standard 209B.
The unit will have HEPA filters, a washable and reusable pre-filter, a work surface and side walls of type 304 stainless steel construction,
duplex electrical receptacles, high velocity return air slots that provide an air curtain at the work area, work surface and side walls and
blowers with an average velocity of 100 fpm. Used for work with non-hazardous materials where clean particle free air is required. 6 foot
model, other sizes available.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 762 of 1462