MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN CS220
Name Cupsink
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6530
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing B | Cold water and drain
Volts1 0
Utility2: Electrical . |
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 0
Phase2 0
Amps1 0
Amps2 0
Weight (lbs) 7 Weight (kgs) 4
Height (in) 9 Height (cen) 23
Width (in) 8 Width (cen) 20
Depth (in) 5 Depth (cen) 13
Volts2 0
Hertz 0
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 0
Watts2 0
Description
Unit of Issue EA
Group Fixed Casework
A stationary basin, usually mounted in a laboratory counter top or ledge, connected with a drain and provided with a single-service cold
water faucet, for drainage of various fluids. The cup-sink is manufactured in a variety of sizes, shapes (round, oval, rectangular), and
materials (epoxy resin, stainless steel, polyolefin, and glass). For general purpose use in a lab area.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 141 of 1462