MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN L2337
Name Canopy, Hood, Fume, 6 foot
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6640
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical F | Special electrical requirements
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc E | Vent to atmosphere
Phase1 1
Phase2 0
Amps1 12
Amps2 0
Weight (lbs) 100 Weight (kgs) 45
Height (in) 21 Height (cen) 53
Width (in) 72 Width (cen) 183
Depth (in) 30 Depth (cen) 76
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour
Watts1 1440
Watts2 0
Description
Unit of Issue EA
Group Laboratory Equipment
Canopy fumehood. The unit includes a switched fan unit with pilot light; corrosion resistant steel, aluminum, or chemical resistant and fire
retardant seamless fiberglass construction; dimensions as indicated on design drawings; fire suppression systems and any other special
requirements to be defined during the facility design. It also includes a 3/4 horsepower motor blower. The static pressure loss shall not
exceed 0.91 at 1290 cfm and 1.65 at 1935 cfm. It is equipped with baffles to maximize slot velocities and control fumes. Used in
laboratories for low to moderate risk biological agents. Other sizes may be available. Blower motor mounted separate from the canopy
and may not be included in the size specification.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 771 of 1462