MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN L2320
Name Cabinet, Bio Safety, Class II/B1, F/S, Vert, 4ft
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6640
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical F | Special electrical requirements
Utility3: Med Gas B | Vacuum
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc E | Vent to atmosphere
Phase1 1
Phase2 0
Amps1 20
Amps2 0
Weight (lbs) 845 Weight (kgs) 384
Height (in) 97 Height (cen) 246
Width (in) 54 Width (cen) 137
Depth (in) 34 Depth (cen) 86
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 2400
Watts2 0
Description
Unit of Issue EA
Group Laboratory Equipment
Class II, type B1, bio safety cabinet. This is a vertical, freestanding unit. The interior work surfaces shall be constructed of type 304
stainless steel and the exterior shall be of 16 gauge or heavier steel. The unit utilizes a 30% recirculated air and 70% direct exhaust
through an in-house duct system, the face velocity is 100 fpm and includes an audible alarm when the window is at an unsafe operating
level. It includes grounded duplex receptacles and two HEPA filters zero-probed. Used for low to moderate risk biological agents treated
with minute quantities of toxic chemicals and trace amounts of radionuclides. A 4 foot cabinet is presented, other sizes are available.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 766 of 1462