MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN A1205
Name Lift System, Overhead, Patient Room w/Bath
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical F | Special electrical requirements
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc J | Wall/ceiling support required
Phase1 1
Phase2 0
Amps1 5
Amps2 0
Weight (lbs) Weight (kgs)
Height (in) Height (cen)
Width (in) Width (cen)
Depth (in) Depth (cen)
Description
Unit of Issue EA
Group Architectural
An overhead rail system specifically designed for patient lifting and movement for a single bed patient room including the bathroom. The
system will consist of recessed or ceiling mounted primary and secondary rails, lift motor with rolling carriage, patient harness or seat,
and a hand controller or control box with charger. System will facilitate lifting and movement of patient to and from bed to gurney, chair,
bath, commode, or other requirement. Minimum lift capability is 550 pounds. Custom design of track layout by manufacturer is essential
to meet individual facility requirements.
NSN
Volts2 0
Hertz 0
Hertz Dep 0
Hertz Switch -1
BTU / Hour 0
Watts1 600
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 56 of 1462
Watts2