MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN L2200
Name Hood, Fume, Floor Standing
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6640
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing I | Drain only
Volts1 120
Utility2: Electrical B | 120 volt, special outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc E | Vent to atmosphere
Phase1 1
Phase2 0
Amps1 15
Amps2 0
Weight (lbs) 756 Weight (kgs) 344
Height (in) 98 Height (cen) 249
Width (in) 49 Width (cen) 124
Depth (in) 35 Depth (cen) 89
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1800
Watts2 0
Description
Unit of Issue EA
Group Laboratory Equipment
Floor standing fume hood. The unit presented is 4 Ft but is available in other sizes. It will include a fluorescent light fixture, blower switch
with pilot light, at least one duplex receptacle, a cup sink and shall be acid resistant. The minimum average face velocity shall be 100 fpm.
It Includes a safety glass sash resistant to heat of up to 71 degrees centigrade. Static pressure loss is not to exceed 0.22 inches. The fume
hood also has adjustable baffles. Other custom options are available. Used in laboratories to prepare samples requiring the use of toxic
and or flammable materials.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 755 of 1462