MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN K2750
Name Fryer, Gas, 30-40 Lb. Capacity, Free Standing
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 7310
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical B | 120 volt, special outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas A | Natural gas
Utility6: Misc E | Vent to atmosphere
Phase1 1
Phase2 0
Amps1 5
Amps2 0
Weight (lbs) 220 Weight (kgs) 100
Height (in) 56 Height (cen) 142
Width (in) 16 Width (cen) 41
Depth (in) 35 Depth (cen) 89
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 120000
Watts1 600
Watts2 0
Description
Unit of Issue EA
Group Food Service Equipment
Two basket gas heated deep fat fryer. The unit is freestanding, holds 30-40 lb. of hot oil and has leveling legs, swing up or removable
corrosion resistant heating elements, solid state or programmable controls, self-diagnostics, a backsplash and an electronic or
thermostatic over-temperature shutoff. The unit can have one large oil tank holding both baskets or two smaller tanks holding one
basket each. The basic unit has painted sides, an aluminized back and a stainless steel front and top; a full stainless steel enclosure is
optional. Some models have automatic basket lifts. The fryer can run on either natural or liquid propane gas. The database height
dimension refers to a unit with its coils lifted for cleaning. The electrical specifications are for the automatic basket lifts and power
controls. See the manufacturers' specifications for required clearances from combustible materials and open heating elements.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 625 of 1462