MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN V0055
Name Washer/Sanitizer, Cage, Steam
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6640
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing D | Cold and hot water and drain
Volts1 230
Utility2: Electrical F | Special electrical requirements
Utility3: Med Gas D | Air, high pressure (85 PSIG) max
Utility4: Misc Gas A | Steam
Utility5: Non-Med Gas . |
Utility6: Misc E | Vent to atmosphere
Phase1 3
Phase2 0
Amps1 70
Amps2 0
Weight (lbs) 12000 Weight (kgs) 5448
Height (in) 92 Height (cen) 234
Width (in) 54 Width (cen) 137
Depth (in) 252 Depth (cen) 640
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 24000
Watts1 27886
Watts2 0
Description
Unit of Issue EA
Group Veterinary
Cage washer/sanitizer. Characteristics/components include tunnel type; enclosed steam cabinet; type 304 CRS; integral 39 gallon wash
and rinse tank; 36 inch wide CRS conveyer belt with speed controller; 3 HP motor-driven pumps for wash and rinse section; automatic
controls in CRS switch box; operates on 115 VAC; start-stop buttons in oil-tight switch boxes at each end; thermostatically controlled
heaters to provide 160-190 degrees F. wash and rinse water and 180 degrees F. sanitizing water; two vent stacks with automatic dampers;
marine light in tunnel; 1 inch NPT hot water (20-60 PSIG) 1 inch NPT steam (10-60 PSIG) 3/4 inch NPT return, 8-12 inch diameter vent and
3 inch NPT drain. Unit is used for washing and processing general purpose cages, cage pans and accessory cage equipment.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 1309 of 1462