MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN T7550
Name Saw, Radial Arm
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 3405
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 220
Utility2: Electrical C | 208/220 volt
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 17
Amps2 0
Weight (lbs) 350 Weight (kgs) 159
Height (in) 64 Height (cen) 163
Width (in) 35 Width (cen) 89
Depth (in) 32 Depth (cen) 81
Volts2 0
Hertz 60
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 3740
Watts2 0
Description
Unit of Issue EA
Group Shop Equipment/Tools
Radial arm saw. Characteristics/components include floor model unit; 12 inch diameter blade with an arm which permits saw blade to
rotate a full 360 degrees above worktable; 1-1/2 HP motor with an automatic Electro-mechanical brake that is built into the motor and
stops the blade automatically in seconds after switch is turned off; 45 degree to 90 degree level position stop; and a table size of 25-1/2 X
30" (635 X 762 mm). This unit is used for wood cutting in woodworking shops.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 1289 of 1462