MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN D9880
Name Sink, CRS, Drop-In, 7.5hx16wx16d or 7.5hx18wx14d
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing D | Cold and hot water and drain
Volts1 0
Utility2: Electrical . |
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 0
Phase2 0
Amps1 0
Amps2 0
Weight (lbs) 27 Weight (kgs) 13
Height (in) 9 Height (cen) 23
Width (in) 22 Width (cen) 56
Depth (in) 21 Depth (cen) 53
Volts2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Drop-in corrosion resistant sink made from 18 gauge stainless steel with a 7.5h x 16w x 16d bowl (256 sq. in.), or an 7.5h x 18w x 14d bowl
(252 sq. in.). The unit has a faucet, a drain, a back ledge with three precut fixture holes and requires mounting in a cabinet or counter.
The sink's overall outer dimensions vary slightly by manufacturer. The sink is used in dental operatories and laboratories for dentists,
assistants and technicians to wash hands, instruments or accessories.
Hertz
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 0
Watts2 0
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 242 of 1462