MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN K9300
Name Washer, Pressure w/Sanitizer
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 7310
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing D | Cold and hot water and drain
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 15
Amps2 0
Weight (lbs) 140 Weight (kgs) 64
Height (in) 38 Height (cen) 97
Width (in) 28 Width (cen) 71
Depth (in) 39 Depth (cen) 99
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1800
Watts2 0
Description
Unit of Issue EA
Group Food Service Equipment
Pressure washer for cleaning and sanitizing kitchen or other areas. This is a wall mounted, motor operated unit with a spray gun. The
washer sprays a detergent solution on each item to be cleaned and then rinses them using a combination of water and high pressure that
blasts away the loosened dirt and grease. The washer can be either a stand alone unit or part of a set of stations operating from a central
control. See JSN K1350 for the mobile version of this unit. The unit is used for cleaning in commercial areas and institutions such as
hospitals.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 695 of 1462