MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN D4310
Name Press, Flask, Pneumatic
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas D | Air, high pressure (85 PSIG) max
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 5
Amps2 0
Weight (lbs) 95 Weight (kgs) 44
Height (in) 22 Height (cen) 56
Width (in) 10 Width (cen) 25
Depth (in) 9 Depth (cen) 23
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 600
Watts2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Pneumatic press for a single denture molding flask. The unit applies 3000 or more pounds of pressure to the denture molding flask to
obtain as hard a curing set of the denture material as possible. Depending on the manufacturer, a unit will operate directly from an air
supply line or generate its own internal pneumatic pressure.
JSN D4320
Name Press, Flask, Hydraulic, Single Flask
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 6520012433283
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 0
Utility2: Electrical . |
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 0
Phase2 0
Amps1 0
Amps2 0
Weight (lbs) 25 Weight (kgs) 12
Height (in) 18 Height (cen) 46
Width (in) 16 Width (cen) 41
Depth (in) 10 Depth (cen) 25
Volts2 0
Hertz 0
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 0
Watts2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Single flask hydraulic press. The press is used in dental prosthodontic laboratories to load acrylic pressure packs for dentures and
partials. The unit's self-contained hydraulics allow up to 3500 pounds of force with minimal physical effort by means of a hand lever.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 207 of 1462