MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN D0965
Name Plaster Dispensing System, Dental Lab, Power, W/M
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Wall mounted dispensing system for dental plasters, alginates and stone modeling powders. The unit consists of a wall rail, stainless steel
or plastic holding bins and a hoist. The hoist lowers the individual bins to the floor for refilling and then lifts the filled bins back up for
remounting on the wall rail. Each bin mount has an electric motor for agitating the plaster in the bins while its being dispensed. Multiple
electrical outlets may be needed for this unit. The wall to which the unit is mounted will require reinforcing to support the unit's weight.
The database information reflects the data for a three bin unit filled with plaster powder; two and four bin units are available.
A
A
A
Amps1 15
Amps2 0
Weight (lbs) 655 Weight (kgs) 298
Height (in) 43 Height (cen) 109
Width (in) 69 Width (cen) 175
Depth (in) 18 Depth (cen) 46
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1800
Watts2 0
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 190 of 1462