MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN D0710
Name Countertop, Epoxy Resin
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 0
Utility2: Electrical . |
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 0
Phase2 0
Amps1 0
Amps2 0
Weight (lbs) 50 Weight (kgs) 23
Height (in) 8 Height (cen) 20
Width (in) 12 Width (cen) 30
Depth (in) 30 Depth (cen) 76
Volts2 0
Hertz 0
Hertz Dep 0
Hertz Switch 0
BTU / Hour 0
Watts1 0
Watts2 0
Description
Unit of Issue FT
Group Dental Equipment and Dental Casework
Modified epoxy resin 3/4" to 1-1/4" thick countertop (depending on vendor) with a back rail and shelf. The service ledge (back rail and
shelf) is approximately 6 inches high and 6 inches front to back. The front face of the service ledge can be the base cabinet material
(usually painted steel) or epoxy resin. The shelf section is removable to provide access to gas, electrical, and water connections. The
database reflects 30" deep countertops priced by the linear foot. The height dimension is from the underside of the working surface to
the top surface of the back service ledge.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 170 of 1462