MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN D0870
Name Hood, Collecting, Dust
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6520
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas B | Vacuum
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 10
Amps2 0
Weight (lbs) 54 Weight (kgs) 25
Height (in) 13 Height (cen) 33
Width (in) 29 Width (cen) 74
Depth (in) 21 Depth (cen) 53
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1200
Watts2 0
Description
Unit of Issue EA
Group Dental Equipment and Dental Casework
Dust collecting hood approximately 17" H x 29" W x 21" D for pumice polishing in dental laboratories. The hood is constructed of copper
or heavy gauge sheet steel with a silver enamel finish. It has a light switch, incandescent lamp(s) and removable pumice pans. The hood
removes between 200 and 365 cubic feet per minute of air volume with a velocity of approximately 4000 feet per minute through a 3 inch
duct.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 178 of 1462