MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN L2270
Name Hood, Fume, Radioisotope
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army A | Contractor Furnished, Contractor Installed
Navy A | Contractor Furnished, Contractor Installed
USAF A | Contractor Furnished, Contractor Installed
VA A | Contractor Furnished, Contractor Installed
IHS A | Contractor Furnished, Contractor Installed
Utilities
NSN 6640
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing B | Cold water and drain
Volts1 120
Utility2: Electrical D | 120 and 208/220 volt
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc E | Vent to atmosphere
Phase1 1
Phase2 1
Amps1 20
Amps2 10
Weight (lbs) 910 Weight (kgs) 414
Height (in) 96 Height (cen) 244
Width (in) 48 Width (cen) 122
Depth (in) 34 Depth (cen) 86
Volts2 208
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 2400
Watts2 2080
Description
Unit of Issue EA
Group Laboratory Equipment
Radioisotope fumehood. The unit requires a charcoal trap filter, lead-lined or HEPA filter as required by codes and use criteria in the
exhaust stack, not part of this hood. Other characteristics are that it be strong enough to support lead shielding bricks, have at least two
duplex receptacles and a cup sink. The minimum average face velocity shall be 100 fpm and the static pressure loss through the hood
shall not exceed 0.2 inches of water at 100 fpm face velocity (700 CFM).
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 760 of 1462