MIL-STD 1691 Master Equipment List - The Whole Building Design ...

JSN M2505
Name Patching Machine, Linen, Thermal
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 3510
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 115
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas D | Air, high pressure (85 PSIG) max
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 10
Amps2 0
Weight (lbs) 65 Weight (kgs) 30
Height (in) 21 Height (cen) 53
Width (in) 8 Width (cen) 20
Depth (in) 23 Depth (cen) 58
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1150
Watts2 0
Description
Unit of Issue EA
Group Miscellaneous
Heat seal machine. This electronic high pressure machine is designed for fast, strong application of computer labels, embroidered or
printed emblems, hot paper transfers and for mending patches. Machine is designed as a table model unit for transfer and mending. Unit
includes top and bottom heat. This high pressure design is excellent for the application of garment labels, and for mending patches and
transfers at relatively short cycle times.
JSN M2600
Name Vacuum, Wet/Dry, HEPA Filtration
Logistical Category (LOGCAT) Fund Source Weights and Measures (Typical Only)
Army C | Government Furnished, Government Installed
Navy C | Government Furnished, Government Installed
USAF C | Government Furnished, Government Installed
VA C | Government Furnished, Government Installed
IHS C | Government Furnished, Government Installed
Utilities
NSN 7910
NOTE: Values shown are based on standard typicals used for programming purposes. The contractor remains responsible to
develop and coordinate the design / construction in accordance with actual equipment selection.
Utility1: Plumbing . |
Volts1 120
Utility2: Electrical A | 120 volt, conventional outlet
Utility3: Med Gas . |
Utility4: Misc Gas . |
Utility5: Non-Med Gas . |
Utility6: Misc . |
Phase1 1
Phase2 0
Amps1 10
Amps2 0
Weight (lbs) 75 Weight (kgs) 34
Height (in) 46 Height (cen) 117
Width (in) 22 Width (cen) 56
Depth (in) 24 Depth (cen) 61
Volts2 0
Hertz 60
Hertz Dep -1
Hertz Switch 0
BTU / Hour 0
Watts1 1200
Watts2 0
Description
Unit of Issue EA
Group Miscellaneous
Wet/dry vacuum cleaner with HEPA filtration. Unit consists of a minimum 10 gallon capacity corrosion resistant waste tank, two stage
vacuum motor and dual filtering system mounted on casters. Vacuum is designed for use in patient care areas and operating room suites.
Thursday, April 21, 2011 MIL-STD 1691 | PPMD
Page 899 of 1462