Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Screen
FRQ
SGL
A frequency offset ≠ 0 Hz has been set.
The scan/sweep is set to SINGLE SCAN or SINGLE SWEEP.
1-
2-
3-
4-
AP
MA
MI
SA
AV
RM
QP
AC
GAT
TRG
EXT
Subtraction Trace 1 - Trace active (: numeric value) or
subtraction Trace 1 - Reference Line active (: R)
Subtraction Trace 2 - Trace active (: numeric value) or
subtraction Trace 1 - Reference Line active (: R)
Subtraction Trace 3 - Trace active (: numeric value) or
subtraction Trace 1 - Reference Line active (: R)
Subtraction Trace 4 - Trace active (: numeric value) or
subtraction Trace 1 - Reference Line active (: R)
For trace (n = 1 to 4) the detector is set to AUTOPEAK.
For trace (n = 1 to 4) the detector is set to MAX PEAK.
For trace (n = 1 to 4) the detector is set to MIN PEAK.
For trace (n = 1 to 4) the detector is set to SAMPLE.
For trace (n = 1 to 4) the detector is set to AVERAGE.
For trace (n = 1 to 4) the detector is set to RMS.
For trace (n = 1 to 4) the detector is set to QUASIPEAK.
For trace (n = 1 to 4) the detector is set to AC VIDEO (ESIB-B1)
The frequency sweep is controlled via the EXT TRIG/GATE connector.
The instrument is not triggered in FREE RUN mode.
The unit is configured for operation with external reference
75 Ω The input impedance of the unit is set to 75 Ω.
MAC
PRN
VIEW
AVG
MIX
SID
AID
Macro recording active.
A printout is taking place. PRN overwrites the enhancement label
MAC.
Trace (n = 1 to 4) is set to VIEW
Trace (n = 1 to 4) is set AVERAGE
The external mixer output is switched on (option FSE-B21).
External mixer output: SIGNAL ID is switched on (option FSE-B21).
External mixer output: AUTO ID is switched on (option FSE-B21).
1088.7531.12 3.7 E-13