Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Analyzer - Traces
TRACE 1-DETECTOR submenu
DETECTOR
TRACE 1
DETECTOR
AUTO
SELECT
DETECTOR
AUTO PEAK
DETECTOR
MAX PEAK
DETECTOR
MIN PEAK
DETECTOR
SAMPLE
The DETECTOR softkey opens a submenu to select the
detector.
Softkey AC VIDEO is available only if the instrument is
equipped with the linear video output (option ESIB-B1)
The detector may be independently selected for each trace.
Mode AUTO SELECT sets the best suitable detector for each
trace display mode (Clear Write, Max Hold oder Min Hold).
Only one of the softkeys for the detectors can be activated at
any one time.
DETECTOR
RMS
DETECTOR
AVERAGE
DETECTOR
AC VIDEO
AUTO
SELECT
DETECTOR
AUTOPEAK
The AUTO SELECT softkey (= default) selects the optimum detector for the
selected trace display mode (clear write, max hold, min hold).
Trace-mode
Detector
Clear/Write
Autopeak
Average
Sample
Max Hold
Max Peak
Min Hold
Min Peak
IEC/IEEE-bus command
:[SENSe:]DETector:AUTO ON|OFF
The DETECTOR AUTOPEAK softkey selects the autopeak detector.
IEC/IEEE-bus command :[SENSe:]DETector APEak
DETECTOR
MAX PEAK
DETECTOR
MIN PEAK
The DETECTOR MAX PEAK softkey selects the max peak detector. It is
recommended for pulse-like signals.
IEC/IEEE-bus command :[SENSe:]DETector POSitive
The DETECTOR MIN PEAK softkey selects the min peak detector. Weak
sinewave signals can be brought out clearly against noise by using this
detector. For a composite signal made up of sinewaves and pulse-like-like
signals the pulse signals are suppressed.
IEC/IEEE-bus command :[SENSe:]DETector NEGative
1088.7531.12 4.233 E-15