Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Initial Configuration
ESIB
General Configuration – SYSTEM and CONFIGURATION Key
Groups
ESIB Initial Configuration – PRESET Key
SYSTEM
PRESET CAL
DI AY INFO
Using the PRESET key, the ESIB can be brought to a predefined initial state
equivalent to the state after power on. All previous setting are deleted if they
were not previously saved in memory. Returning to the PRESET state is not
critical with regard to an arbitrary signal which may still be present at the input
as long as the signal is within the specified voltage range.
Note:
The initial state set by the PRESET key can be adapted to the
user requirements using the AUTO RECALL function. When the
PRESET key is pressed, the AUTO RECALL dataset is loaded.
For further information refer to Section "Saving and Recalling
Data Sets".
IEC/IEEE- bus command
:*RST
Pressing the PRESET key, causes the ESIB to enter its initial state according to the following table:
Table 4-1
Parameter
Initial state of the ESIB
Setting
Mode
EMI Receiver
Receiver Frequency
100 MHz
RF Attenuation
Auto
Preamplification
off
Input Input 1
Detector
AV
Measurement Time
100 ms
IF Bandwidth (RES BW)
120 kHz
Demodulation
off
Trigger
free run
1088.7531.12 4.2 E-15