Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
DISPlay Subsystem
:DISPlay[:WINDow]:TRACe:MODE WRITe | VIEW | AVERage | MAXHold | MINHold |
FRESult
This command defines the type of display and the evaluation of the traces.
For selection FRESult (display of final measurement) only suffix 3 or 4 is valid for TRACe.
Example: ":DISP:TRAC3:MODE MAXH"
Features: *RST value: WRITe for TRACe1, STATe OFF for TRACe2 to 4
SCPI: device-specific
Modes:
R, A, VA
:DISPlay[:WINDow]:TRACe:MODE:CWRite ON | OFF
This command selects continuous display of the measured values (continuous write).
Example: ":DISP:TRAC3:MODE:CWR ON"
Features: *RST value: OFF
SCPI: device-specific
Mode:
VA
:DISPlay[:WINDow]:TRACe:MODE:ANALog ON | OFF
This command selects continuous display of the measured values in the analyzer mode (analog
trace).
Example: ":DISP:TRAC3:MODE:ANAL ON"
Features: *RST value: OFF
SCPI: device-specific
Mode:
A
:DISPlay[:WINDow]:TRACe:MODE:HCONtinuous ON | OFF
This command defines whether the traces in the min hold/max hold mode are reset after some
definite parameter changes.
Example: ":DISP:TRAC3:MODE:HCON ON"
Features: *RST value: OFF
SCPI: device-specific
Mode:
A
OFF
The traces are reset after some definite parameter changes.
ON
This mechanism is switched off.
In general, parameter changes require a restart of the measurement before results are evaluated
(e.g. with markers). For those changes that are known to require a new measurement (e.g.
modification of the span), the trace is automatically reset so that erroneous evaluations of previous
results are avoided. This mechanism can be switched off for those exceptional cases where the
described behavior is unwelcome.
The numeric suffix in WINDow is not significant.
1088.7531.12 6.71 E-15