Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Options
ESIB
½ Mark "GPIB0" in the "GPIB Board" list.
½ Mark "AT-GPIB/TNT" in the "Board Type"
list.
½ Confirm the selection with "OK".
The "GPIB Configuration" menu is
displayed again.
½ Click button "Configure".
The "GPIB0 (AT-GPIB/TNT)" menu for
configuring the board is opened.
Configuring the board
½ Set "3" in the "Interrupt Level" list.
½ Click button "Software".
The menu is extended.
½ Deactivate (= no tick) "Enable Auto Serial
Polling" in the "Advanced Items" field.
½ Quit the menu with "OK".
The "GPIB Configuration" menu is displayed
again.
Note:
The settings of the following parameters
should not be no longer modified.
Board Type ......... AT-GPIB/TNT
Base I/O Address ......... 02C0h
Interrupt Level .............. 3
DMA Channel .................. 5
Enable Auto Serial Polling .. No
1088.7531.12 1.40 E-3