Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

SENSe Subsystem
ESIB
SENSe:SWEep Subsystem
This subsystem controls the sweep parameters.
COMMAND PARAMETERS UNIT COMMENT
[SENSe]
:SWEep
:TIME
:AUTO
:FMEasurement
:COUNt
:EGATe
:LEVel
:TYPE
:POLarity
:HOLDoff
:LENGth
:SOURce
:GAP
:PRETrigger
:TRGTogap
:LENGth
:SPACing
LEVel | EDGE
POSitive|NEGative
EXTernal | RFPower
LINear | LOGarithmic | AUTO
S
--
S
--
--
V
--
--
S
S
--
--
S
S
S
:[SENSe:]SWEep:TIME
This command defines the duration of a single measurement or the duration of the sweep.
The allowed value range depends on the operating mode (see Chapter 4, Softkeys MEAS TIME
(receiver mode) and SWEEP TIME MANUAL (analyzer mode)).
Example: ":SWE:TIME 10s"
Features: *RST value - (AUTO is set to ON)
SCPI: conforming
Modes:
R, A, VA-A
In analyzer and vector analyzer mode, automatic coupling is switched off if SWEep:TIME is directly
programmed.
:[SENSe:]SWEep:TIME:AUTO ON | OFF
This command switches the automatic coupling of the sweep time for the frequency span or
bandwidth settings.
Example: ":SWE:TIME:AUTO ON"
Features: *RST value: ON
SCPI: conforming
Mode:
A
If SWEep:TIME is directly programmed, automatic coupling is switched off.
1088.7531.12 6.150 E-15