Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

TRACe Subsystem
ESIB
- 4 byte:trace4 active (0/1)
- n*4 bytes:measurement results of trace 1 if trace 1 is active
- n*4 bytes:measurement results of trace 2 if trace 2 is active
- n*4 bytes:measurement results of trace 3 if trace 3 is active
- n*4 bytes:measurement results of trace 4 if trace 4 is active
- n*1 byte:status information per measurement result:
bit 0: underrange trace1; bit 1: underrange trace2;bit 2: underrange trace3;
bit 3: underrange trace4; bit 4: overrange trace1 to trace4
STATus is only possible in form of a query during scan measurements. 1 byte status
information per measurement result is transmitted:
bit 0: underrange trace1; bit 1: underrange trace2;bit 2: underrange trace3;
bit 3: underrange trace4;bit 4: overrange trace1 to trace4
FINAL1, FINAL2, FINAL3 and FINAL4 are only possible in form of a quey. The final
measurement values are transmitted.
:TRACe:COPY :TRACe:COPY TRACE1| TRACE2| TRACE3| TRACE4 ,
TRACE1| TRACE2| TRACE3| TRACE4
This command copies data from one trace to another. The second operand designates the source,
the first operand the destination of the data to be copied.
Example: ":TRAC:COPY TRACE1,TRACE2"
Features: *RST value:
SCPI: conforming
Modes:
R, A, VA
This command is an event and therefore has no query and no *RST value assigned.
:TRACe:FEED:CONTrol ALWays | NEVer
This command switches block data transmission during a scan on and off.
Example: "TRAC:FEED:CONT ALW"
Features: *RST Value: NEVer
SCPI: conforming
Mode:
R
The block size dependens on the scan time, the trace number is not evaluated.
1088.7531.12 6.176 E-15