Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
SENSe:SCAN - Subsystem
This subsystem controls the parameters for the receiver scan data. The numeric suffix in
[SENSe]SCAN is not significant.
COMMAND PARAMETER UNIT COMMENT
[SENSe]
:SCAN
:STARt
:STOP
:STEP
:BANDwidth
:RESolution
:TIME
:INPut
:TYPe
:ATTenuation
:AUTO
:GAIN
:STATe
:AUTO
:RANGes
[:COUNt]
INPUT1 | INPUT2
HZ
HZ
HZ
HZ
s
dB
--
--
--
--
:[SENSe:]SCAN:STARt f min to f max
This command defines the start frequency of a receiver subscan.
Example: ":SCAN1:STAR 50kHz"
Features: *RST value: 150 kHz (range1)
30 MHz (range2)
SCPI: device-specific
Mode:
R
:[SENSe:]SCAN:STOP f min to f max
This command defines the stop frequency of a receiver subscan.
Example: ":SCAN1:STOP 50kHz"
Features: *RST value: 30 MHz (range1)
1 GHz (range2)
SCPI: device-specific
Mode:
R
:[SENSe:]SCAN:STEP f min to f max
This command defines the step size for the frequency of a receiver subscan.
Example: ":SCAN1:STEP 100Hz"
Features: *RST value: 4 kHz (range 1)
40 kHz (range 2)
SCPI: device-specific
Mode:
R
1088.7531.12 6.147 E-15