Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB- Receiver
ESIB
CONFIGURATION MODE - EMI RECEIVER menu
RUN
SCAN
HOLD
SCAN
REF LEVEL
AUTO
HOLD
SCAN
STOP
SCAN
CONTINUE
SCAN
REF CONT LEVEL AT
REC AUTO FREQ
CONTINUE
AT HOLD
STOP
SCAN
The RUN SCAN softkey starts the frequency
scan with the selected settings. The HOLD
SCAN submenu is displayed instead of the
menu shown before the scan is started.
IEC/IEEE-bus command
:INITiate2[:IMMediate]
HOLD
SCAN
The HOLD SCAN softkey interrupts the scan.
The CONTINUE SCAN submenu is displayed. The scan stops at
the frequency at which it was interrupted until it is continued with
the CONT AT REC FREQ or CONTINUE AT HOLD softkeys.
While the scan is stopped, the receiver settings can be changed,
eg for a detailed analysis of the recorded trace.
IEC/IEEE-bus command
:HOLD
CONT AT
REC FREQ
With the CONT AT REC FREQ softkey the scan is continued at
the current receiver frequency when the receiver frequency is
lower than the frequency at which the scan was interrupted.
Otherwise the scan continues at the frequency at which it was
interrupted.
IEC/IEEE-bus command :INITiate2[:IMMediate]
CONTINUE
AT HOLD
With the CONT AT HOLD softkey the scan is continued where it
was interrupted. The scan is always continued with the settings
in the scan table.
IEC/IEEE-bus command --
STOP
SCAN
The STOP SCAN softkey stops the scan. Upon restart, scanning
starts at the beginning. The results of the performed
measurements are lost.
IEC/IEEE-bus command :ABORt
1088.7531.12 4.96 E-15