Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Setting the Parameters
There are two types of entry windows:
10.2457535 GHZ
START FREQUENCY
START FREQUENCY OUT OF RANGE
HARDCOPY TITLE
BANDPASS-FILTER TEST 23A
The editing line of the entry window for numeric
parameters allows for display of up to 24
characters. Horizontal scrolling is not possible in
the editing line.
The editing line of the entry window for
alphanumeric parameters allows for display of up
to 60 characters (cf. display section). Maximum
256 characters may be entered. Horizontal
scrolling is possible.
Editing of Numeric Parameters
Calling the entry window:
• Subsequent to calling the entry window, the current value of the numeric parameter including the unit
is displayed in inverted color. The cursor is not displayed in this state. The transparent data entry
window has no background color.
• The entry window is closed upon pressing the key CLR.
Editing mode:
• Pressing a number, sign or decimal point key causes the value and unit to be deleted. The new value
is output left-justified. The individual characters are entered in insert mode. If the maximum amount of
characters for the mantissa or the exponent has been entered, no further entry is possible (no
horizontal scrolling). If characters are positioned to the right of the cursor, they are shifted right when
reaching the maximum length and get lost.
• Pressing the keys DATA VARIATION or causes normal representation of the current value.
The unit is no longer displayed and the cursor precedes the first digit of the mantissa ( ) or follows
the last digit entered ( ). The DATA VARIATION keys and change the numeric value of the
cursor.
• Pressing the DATA VARIATION keys or or the roll-key causes the original parameter value to
be restored and modified according to the defined step size for this parameter.
• The data management of the instrument stores the previous value of a parameter in addition to the
current value. The BACK key allows for toggling between these two values.
Termination and abortion of entry:
• The editing mode is terminated by pressing a unit key. The validity of the new parameter value is
checked and accepted for the instrument setting. If an error occurs, a corresponding error message is
displayed in the status line of the editing field, e.g., "Out of range", "Value adjusted", etc.
• Editing of a parameter can be aborted by pressing the key CLR. The original parameter is then
displayed again. The entry window is closed by pressing the CLR key again.
• Pressing a key or softkey subsequent to starting the entry causes the entry to be aborted and the
entry window to be closed. If the same softkey which has opened the entry window is activated during
entry, the original value is restored and displayed.
1088.7531.12 3.17 E-13