Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Example - Level and Frequency Measurement
ESIB
RES BW
120 kHz
RES BW
½ Press the RES BW softkey.
A window with the currently set resolution bandwidth
is opened (120 kHz in the example).
DATA ENTRY
9
dB
µV kHz
ns
RES BW
9 kHz
½ Press 9 on the numeric keypad and terminate the
entry by pressing kHz.
The new value for the resolution bandwidth is
displayed.
A measurement time of 1 kHz should be set.
MEAS TIME
MEAS TIME
100 ms
½ Press the MEAS TIME softkey.
A window with the currently set measurement time
is opened (100 ms in the example).
1
DATA ENTRY
dBm
mV MHz
ms
MEAS TIME
1 ms
½ Press 1 on the numeric keypad and terminate the
entry by pressing MHz.
The new value for the measurement time is
displayed.
5. Applying the signal
½ Connect RF cable to input 2.
RUN
SCAN
6. Starting the scan
½ Press the RUN SCAN softkey.
The measurement with the selected PEAK and
AVERAGE detectors is continuously repeated
because the default setting CONTINUOUS SCAN
remains unchanged.
At the same time the HOLD SCAN and STOP
SCAN softkeys are displayed with the aid of which
the scan can be interrupted (HOLD SCAN) or
aborted (STOP SCAN).
In the example the scan should be aborted.
1088.7531.12 2.8 E-3