Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
UNIT Subsystem
UNIT Subsystem
The UNIT subsystem is used to switch the basic unit of setting parameters. In split screen mode, a
distinction is made between UNIT1 (screen A) and UNIT2 (screen B).
COMMAND PARAMETERS UNIT COMMENT
UNIT
:POWer
:PROBe
DBM | DBPW | DBPT | WATT |
DBUV | DBMV | VOLT |
DBUA | AMPere
V | W | DB | PCT | UNITLESS |
DBUV_MHZ | DBMV_MHZ |
DBUA_MHZ | DBUV_M | DBUA_M |
DBUV_MMHZ | DBUA_MMHZ
:UNIT:POWer DBM | DBPW | DBPT | WATT | DBUV | DBMV | VOLT | DBUA | AMPere | V | W |
DB | PCT | UNITLESS | DBUV_MHZ |DBMV_MHZ | DBUA_MHZ | DBUV_M |
DBUA_M | DBUV_MMHZ | DBUA_MMHZ
This command selects the default unit for input and output.
Example: ":UNIT:POW DBUV"
Features: *RST value: DBM
SCPI: conforming
Modes:
R, A
:UNIT:PROBe ON | OFF
This command determines whether the coding of a probe which is connected to the front panel is
taken into consideration (ON) or not (OFF).
Example: ":UNIT:PROB OFF"
Features: *RST value: ON
SCPI: device-specific
Modes:
R, A
1088.7531.12 6.179 E-15