Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Manual Operation
3 Manual Operation
Chapter 3 verviews manual operation of the ESIB. This includes a description of the screen, menu
operation and the setting of parameters. There is an overview of the menus at the end of this chapter.
The functions of the menus are described in detail in Chapter 4. Chapter 2 contains a short introduction
which goes through simple measurements step-by-step. The remote control is described in Chapters 5,
6 and 7.
The ESIB is menu-controlled via keys and softkeys. Instrument parameters and test parameters can be
set directly via softkeys or by entering values in entry fields and by making selections from tables.
Softkey are used to select operating modes and the screen mode.
If required, data entry windows and tables also be displayed on the measurement screen.
After switching on the instrument a message about the BIOS version installed is displayed for a few
seconds (e.g. "Analyzer BIOS Rev. 1.2").
The results of the self test is displayed next.
MAINPROCESSOR
SELFTEST STARTING ...
TESTING CMOS ...
DMA CHANNEL ...
INTERRUPTS ...
NMI ...
BASE MEMORY ...
EXTENDED MEMORY ...
HD CAPACITY ...
INIT FLOPPY DRIVE ...
INIT HD ...
SELFTEST DONE,
SYSTEM IS BOOTING ...
Subsequently, the Windows NT controller boots and the instrument then starts measuring. The type of
measurement which was activated prior to last switch-off is performed, as long as no other instrument
configuration was selected via AUTO RECALL in the MEMORY RECALL menu. While the
measurement is being performed other menus and measuring modes can be entered simultaneously.
The measurement results and the settings of the parameters are displayed on the screen.
1088.7531.12 3.1 E-13