Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB- Receiver
ESIB
HOLD
FINAL MEAS
CONTINUE
FINAL MEAS
AUTOMATIC
FINAL
INTER
ACTIVE
SKIP
FREQUENCY
MEASURE
STOP
FINAL MEAS
The HOLD FINAL MEAS softkey interrupts the
automatic run of the final measurement.
The CONTINUE FINAL MEAS submenu
appears.
With the final measurement halted all receiver
settings can be modified for example for
examining the signal in detail.
The mode of the measurement (automatic or
interactive) can again be selected.
The final measurement can be started with the
MEASURE softkey.
IEC/IEEE-bus command --
AUTOMATIC
FINAL
INTER
ACTIVE
SKIP
FREQUENCY
The AUTOMATIC FINAL softkey selects the
automatic mode for the final measurement
(see above).
IEC/IEEE-bus command --
The INTERACTIVE softkey selects the
interactive mode for the final measurement as
described above.
IEC/IEEE-bus command --
The SKIP FREQUENCY softkey skips the next
entry in the FREQUENCY column.
IEC/IEEE-bus command --
MEASURE
The MEASURE softkey continues with the final
measurement. The final measurement starts at
the next frequency entry on the peak list or at a
marked frequency if one or several lines have
been skipped with the SKIP FREQUENCY
softkey.
IEC/IEEE-bus command --
STOP
FINAL MEAS
The STOP FINAL MEAS softkey halts the final measurement.
The final measurement starts from the beginning on a new start.
The previously collected data are lost.
IEC/IEEE-bus command --
1088.7531.12 4.106 E-15