Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Level Display/RF Input - Analyzer
ESIB
INPUT 1
The INPUT 1 softkey activates input 1 (default setting).
INPUT 2
The INPUT 2 softkey activates pulse-resistant input 2. If input 2
is used, the frequency range is restricted to 1 GHz. Higher
frequencies cannot be set.
IEC/IEEE-bus command
:INPut:TYPE INPUT1|INPUT2
INPUT 2
AC COUPLED
INPUT 2
DC COUPLED
The INPUT 2 AC COUPLED and INPUT 2 DC COUPLED
softkeys select AC or DC coupling for RF input 2. The default
setting is AC coupling. The lower frequency limit is 1 kHz.
To indicate that input 2 with AC or DC coupling is activated, the
enhancement label I2A or I2D is shown on the display.
If the ESIB is operated with RF input 1, the softkeys are not
available (enhancement label IN1).
IEC/IEEE-bus command :INPut:COUPling AC | DC
1088.7531.12 4.174 E-15