Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Search Functions - Receiver
ESIB
MARKER
TRACK
The MARKER TRACK softkey couples the current receive frequency to the
marker frequency.
IEC/IEEE bus command
:CALCulate:MARKer:COUPled[:STATe] ON|OFF
SETTINGS
COUPLED
The SETTINGS COUPLED softkey couples the receiver frequency settings
from the corresponding subscans to the marker frequency for functions
TUNE TO MARKER and MARKER TRACK.
IEC/IEEE bus command
:CALCulate:MARKer:SCOupled[:STATe] ON|OFF
MIN
The MIN softkey sets the active marker to the lowest peak on the
corresponding trace.
IEC/IEEE bus command
:CALCulate:MARKer:MIN
:CALCulate:DELTamarker:MIN
NEXT MIN
The NEXT MIN softkey sets the active marker to the next higher of the low
peaks on the corresponding trace.
IEC/IEEE bus command
:CALCulate:MARK:MIN:NEXT
:CALCulate:DELT:MIN:NEXT
NEXT MIN
RIGHT
The NEXT MIN RIGHT softkey sets the active marker to the next low peak to
the right of the current marker.
IEC/IEEE bus command
:CALCulate:MARK:MIN:RIGHt
:CALCulate:DELT:MIN:RIGHt
NEXT MIN
LEFT
The NEXT MIN LEFT softkey sets the active marker to the next low peak to
the left of the current marker.
IEC/IEEE bus command
:CALCulate:MARK:MIN:LEFT
:CALCulate:DELT:MIN:LEFT
PEAK
EXCURSION
The PEAK EXCURSION softkey activates the entry the minimum amount a
signal level must decrease/increase before it is recognised by the search
functions (except PEAK and MIN) as a maximum or minimum.
The entry range is 0 dB to 80 dB with a resolution of 0.1 dB.
IEC/IEEE bus command
:CALCulate:MARKer:PEXCursion 10DB
1088.7531.12 4.130 E-15