Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Receiver - Operation on a Discrete Frequency
EMI RECEIVER Mode
The mode is selected in the CONFIGURATION MODE menu (see also section "Mode Selection - Mode
Key")
The EMI RECEIVER softkey selects the receiver mode (RFI reception) and activates the menu for
setting the receiver parameters.
A window for receiver operation is opened.
The entry for the receiver frequency is automatically active (FREQUENCY softkey).
EMI RECEIVER is the default setting of ESIB.
CONFIGURATION
MODE
SETUP
MODE
ANALYZER
EMI
RECEIVER
RECEIVER
EMI
RECEIVER
RECEIVER
FREQUENCY
EMI
RECEIVER
PEAK
SEARCH
.
.
.
ATTEN
PREAMP
ON OFF
EDIT PEAK
LIST
NO OF
PEAKS
RES BW
PEAK
SUBRANGES
DETECTOR
MARGIN
MEAS TIME
FINAL
MEAS TIME
DEMOD
LISN
SPLIT SCRN
ON OFF
AUTOMATIC
FINAL
DEFINE
SCAN
INTER
ACTIVE
RUN
SCAN
RUN
FINAL MEAS
IEC/IEEE-bus command
:INSTrument[:SELect] RECeiver
In the receiver mode, ESIB acts as a test receiver, ie it measures the level at the set frequency with a
selected bandwidth and measurement time (RES BW and MEAS TIME softkeys). Signal weighting is by
means of the average, max peak, min peak, RMS and quasi-peak detectors (DETECTOR softkey).
The attenuation of the employed input can be selected (ATTEN softkey). The total noise figure can be
reduced by means of a preamplifier (PRAMP ON/OFF softkey).
The functions for the control of line impedance simulating network are available in the SETUP menu.
1088.7531.12 4.75 E-15