Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Firmware Update
ESIB
Installing Windows NT Software
The driver software and the Windows NT system settings are exactly adapted to the measurement
functions of the instrument. Correct operation of the instrument can, therefore, be guaranteed only if the
software and hardware used is released or provided by Rohde & Schwarz.
The use of other software or hardware may cause the ESIB to malfunction.
The latest list of software authorized for use on the ESIB can be obtained from your nearest
Rohde&Schwarz agency (see list of addresses).
After each software installation requiring the administrator identification, "Service Pack" of Windows NT
must be re-installed (also with administrator identification; see section "Controller Function"):
Re-installing Service Pack
½ In the Start menu click "Run".
The entry window opens.
Service Pack 5:
½ Enter "C:\SP5\I386\UPDATE\UPDATE" into the
command line and start installation with "OK".
The following window leads through the installation.
Service Pack 3:
½ Enter "C:\SP3\I386\UPDATE" into the command line
and start installation with "OK".
The following window leads through the installation.
1088.7531.12 1.38 E-3