Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

SENSe Subsystem
ESIB
:[SENSe:]FREQuency:MODE CW | FIXed | SWEep
This command switches between frequency (SWEep) and time (CW | FIXed) domain in the analyzer
mode.
Example: ":FREQ:MODE SWE"
Features: *RST value: CW
SCPI: conforming
Mode:
A
For CW and FIXed, the frequency setting is via command FREQuency:CENTer. In the SWEep
mode, the setting is via commands FREQuency:STARt, STOP, CENTer and SPAN.
:[SENSe:]FREQuency:OFFSet
This command defines the frequency offset of the instrument.
Example: ":FREQ:OFFS 1GHZ"
Features: *RST value: 0 Hz
SCPI: conforming
Modes:
A, VA
:[SENSe:]FREQuency[:CW|:FIXed]
This command defines the receiver frequency
Example: ":FREQ:CW 50MHz"
f min to f max
Features: *RST value: 100MHz
SCPI: conforming
Mode:
R
:[SENSe:]FREQuency[:CW|:FIXed]:STEP
f min .. f max
This command defines the step width of the receiver frequency.
Example: ":FREQ:FIX:STEP 50kHz"
Features: *RST value: 10kHz
SCPI: conforming
Mode:
R
1088.7531.12 6.136 E-15