Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Documentation of Measurement Results
Selection and Configuration of the Printer
The instrument permits two different printers to be configured. One of the devices is defined as the
active device and can be used for hardcopies.
The printers are mainly installed and configured under Windows NT and and the settings are valid for all
Windows applications (see Chapter 1, section "Connecting an Printer"). The active device and the
settings which concern only the output of hardcopies are selected in menu HARDCOPY DEVICE..
HARDCOPY SETTINGS submenu:
HARDCOPY
DEVICE
HARDCOPY
DEVICE
SETTINGS
DEVICE 1
SETTINGS
DEVICE 2
ENABLE
DEV1 DEV2
.
.
.
The HARDCOPY DEVICE softkey switches to the submenu
which is used for the selection/configuration of the two printers.
When the sub-menu is called, the corresponding table is
displayed. The SETTINGS DEVICE 1 softkey is active and the
selection bar is located at the DEVICE1 line in the corresponding
column of the table.
HARDCOPY DEVICE SETTINGS
Device1
WINDOWS METAFILE
Print to File YES
Orientation ---
Device2
CLIPBOARD
Print to File ---
Orientation ---
SETTINGS
DEVICE 1
SETTINGS
DEVICE 2
The SETTINGS DEVICE 1 softkey permits the selection and configuration of the
printer DEVICE 1. The SETTINGS DEVICE 2 softkey is used to configure DEVICE
2.
The actual selection of the active printer takes place with the ENABLE DEV1 DEV2
softkey in the HARDCOPY DEVICE sub-menu.
Device
The selection of the printer/language for DEVICE 1 and DEVICE 2 is made in this
line.
HARDCOPY DEVICE SETTINGS
Device1
WINDOWS METAFILE
Print to File YES
Orientation ---
DEVICE
Device2
CLIPBOARD
CLIPBOARD
WINDOWS METAFILE
Print to File ---
ENHANCED METAFILE
Orientation ---
BITMAP FILE
HP DeskJet 660C
1088.7531.12 4.55 E-15